Fastfeed® CX Powder Induction System | Chemical Powders Into Liquids

Fastfeed® CX is a powder induction and dispersion system for chemical processing applications where powders are difficult to wet out, prone to agglomeration, or create dust and cleanup issues during manual addition. By pulling powders into a liquid stream for immediate wet-out, powder induction reduces floating clumps and helps deliver more consistent dispersion—especially when solids loading, particle behavior, or downstream performance makes uniformity critical.

Compared to dumping powders into the tank, this approach improves control over addition rate and wetting conditions, which can reduce batch variability and rework. Use the sections below to select the right Fastfeed® CX configuration for your materials, flow requirements, and integration needs. For an overview of high shear mixing types and when powder induction is the right tool, refer to our High shear mixer guide.

HOW IT WORKS

FF-XP-full-768x612 The Fastfeed CX system inducts, wets, and disperses countless chemicals, instantly eliminating fisheyes. It disperses at rates up to 500 pounds per minute in a single pass.

The two-stage rotor/stator Dynashear CX high speed emulsifier immediately wets and disperses powders at the particulate level in a single pass. Read more about powder induction with high shear mixing in our guide.

The Fastfeed CX can make any size batch and typically in half the time because powders are inducted into the liquid stream while the batch tank is being filled. Operators add all powdered and liquid ingredients from the safety of floor level.

All powders are dispersed directly into the blend tank, so there are no time-consuming pre-blends or “side batches” that require processors to fill, add powder, mix, transfer, and repeat.

Fastfeed CX

Sizing & Engineering Data

Scroll to the right if needed to view all information.

FF-425

FF-575

Pump HP/kW

7.5 HP/5,5 kW @ 1800 RPM

15 HP/11,5 kW @ 1800 RPM

Mixer HP/kW

7.5 HP/4 kW @ 3600 RPM

20 HP/15 kW @ 3600 RPM

Hopper

3.4 cubic ft

Skid Fittings

2 in. / 5 cm Ø inlet (2.5 in. / 6.35 cm optional) 2 in. / 5 cm Ø outlet

2.5 in. / 6.35 cm Ø inlet (3 in. / 7.62 cm optional) 3″Ø outlet

Dimensions (LxWxH)

60x33x37 in. / 1524x838x940 mm

71x45x38 in. / 1803x1143x965 mm

Additional Customized Solutions

Fastfeed CX Features

STANDARD

Powder hopper with vibrator
Dynashear high shear inlline mixer
Control panel for suction pump and Dynashear
Ergonmic table
Casters
Powder suction pump
Regulating valves
Vacuum gauge

OPTIONAL

Explosion proof components
Control panel
PLC Automation
Optional side flush loop
Optional double mechanical seal for sticky, abrasive or high solids applications
Optional wand attachment
2.5 in. / 6.35 cm inlet on the FF-425 model
3.0 in. / 7.62 cm inlet on the FF-575 model